You are watching: How to disable theft system in chevy malibu
i have actually a 2001 malibu but i don`t have actually the remote control for locks and alarm and also the theeft lock involved how deserve to i disable that my vehicle doesn`t starts any kind of one aid me
Turn top top the ignition, no START.Walk away for at least 10 minutes... SeriouslyTurn off and also then it should start choose normal. This is the GM Passlock defense sysytem.
See more: Organum Added What To Gregorian Chants? Medieval Terms Flashcards
Here is the organization Manual procedure because that relearning the PassLock:Programming Theft Deterrent system ComponentsProgramming instead of Passlock™ Sensor, BCM, or PCMImportantDue to ingredient variability, the automobile theft deterrent (VTD) system must have actually the learn procedure carry out regardless, if the vehicle starts on the first ignition cycle after a VTD repair. Every codes in the theft deterrent module need to be cleared for a relearn.ImportantThe body regulate module (BCM) must be programmed with the suitable RPO configurations before performing find out procedures. Refer to Body regulate Module (BCM) Programming/RPO configuration in Body control System. If replacing the BCM v a GM company Parts to work (SPO) replacement part, the module will discover passlock™ sensor data password immediately. The existing PCM however, must learn the new fuel proceed password when the BCM is replaced. If instead of a PCM v a GM organization Parts operations (SPO) instead of part, after ~ programming, these modules will discover the incoming fuel continue password immediately upon receipt the a password message. As soon as a password message is received, and also a password is learned, a find out procedure should be perform to change this password again. A PCM which has been previously mounted in another vehicle will have actually learned the various other vehicle"s fuel proceed password and also will need a learn procedure ~ programming to discover the existing vehicle"s password. ConditionsUse this procedure ~ replacing any type of of the following:Passlock™ Sensor BCM PCM 10 Minute learn Procedure1. Turn ON the ignition, v the engine OFF. 2. Attempt to start the engine, then release the crucial to ON, vehicle will not start. 3. Watch the protection telltale, after approximately 10 minute the telltale will turn OFF. 4. Revolve OFF the ignition, and also wait 5 seconds. 5. The car is now ready to relearn the Passlock™ Sensor Data password and/or passwords ~ above the following ignition switch shift from turn off to CRANK. ImportantThe auto learns the Passlock™ Sensor Data code and/or password ~ above the next ignition switch shift from turn off to CRANK. You must turn the ignition OFF prior to attempting to start the vehicle.6. Start the engine, the vehicle has now learned the Passlock™ Sensor Data password and/or password. 7. With a scan tool, clear any DTCs if needed, history DTCs will self clear after 100 ignition cycles. Bill